Device Configuration Menu Screen
The following briefly explains each screen accessible from the Device Configuration Menu screen:
GENERAL CONFIGURATION
The General Configuration screen allows the user to monitor and configure operating parameters for the
SNMP COMMUNITY NAMES
The SNMP Community Names screen allows the user to enter new, change, or review the community names used as access passwords for device management operation. Access is limited based on the password level of the user. For details, refer to Section 5.8.
SNMP TRAPS
The SNMP Traps screen provides display and configuration access to the table of IP addresses used for trap destinations and associated community names. For details, refer to Section 5.9.
SWITCH CONFIGURATION
The Switch Configuration screen provides the basic setup options for modifying switch operation in the network. For details, refer to Section 5.10.
ETHERNET FULL DUPLEX CONFIGURATION
The Ethernet Full Duplex Configuration screen allows each 10 Mbps port (1 to 24) to be set for either Standard Ethernet or Full Duplex operation. The screen also indicates whether or not each port is linked to another
SMARTTRUNK CONFIGURATION
The SmartTrunk Configuration screen allows the user to logically group interfaces to aggregate high speed uplinks. Refer to the Cabletron Systems SmartTrunk User’s Guide for additional information.
DEVICE SPECIFIC CONFIGURATION
The Device Specific Configuration Menu screen allows the user to select screens to configure ports or check system resources specific to the
|
