Cabletron Systems 2E43-27R, 2E42-27R manual Enabling/Disabling IP Fragmentation

Chapter 5: Local Management

Event Message Line

WARNING

YOU HAVE ELECTED TO CLEAR NVRAM. THIS WILL CLEAR ALL SYSTEM DEFAULTS INCLUDING BUT NOT LIMITED TO IP ADDRESS, INTERFACE CONFIGURATION, AND COM PORT CONFIGURATION, THEN RESET THE BOARD.

ARE YOU SURE YOU WANT TO CLEAR NVRAM?

YES NO

17421-51

Figure 5-14 Clear NVRAM Warning Screen

5.Press YES and the message “CLEARING NVRAM. REBOOT IN PROGRESS...” displays.

6.The 2E4X-27 clears NVRAM and reboots. All user-entered parameters default to factory default settings.

5.7.12 Enabling/Disabling IP Fragmentation

To enable or disable IP Fragmentation, proceed as follows:

If the 2E4X-27 is being bridged to an FDDI ring (for example,

!via an optional HSIM-F6), IP Fragmentation should be enabled.

CAUTION	If it is disabled, all FDDI frames that exceed the maximum
	Ethernet frame size will be discarded.

1.Use the arrow keys to highlight the IP Fragmentation field.

2.Press the SPACE bar to choose either ENABLED or DISABLED.

3.Use the arrow keys to highlight the SAVE command.

4.Press ENTER. “SAVED OK” displays in the Event Message Line at the top of the screen.

5-30 2E42-27/2E42-27R/2E43-27/2E43-27R User’s Guide