Cabletron Systems 2E43-27R, 2E42-27R manual Setting the Reset Peak Switch Utilization

Chapter 5: Local Management

NVRAM Installed (Read-only)

Indicates the amount of NVRAM installed in the 2E4X-27 and how much of it is currently available.

Current Switch Utilization (Read-only)

Shows how much (percentage of processor capacity) of the 2E4X-27 is currently being used.

Peak Switch Utilization (Read-only)

Shows the peak percentage of maximum switching capacity, since last reset.

Reset Peak Switch Utilization (Toggle)

Allows the user to reset the Peak Switch Utilization field. The switch may be set to either YES or NO as described in Section 5.13.1. YES resets the Peak Switch Utilization field to the current system traffic.

5.13.1 Setting the Reset Peak Switch Utilization

To set the Reset Peak Switch Utilization field to YES or NO, proceed as follows:

1.Use the arrow keys to highlight the Peak Switch Utilization field.

2.Press the SPACE bar to select YES or NO.

3.Use the arrows keys to highlight the SAVE command at the bottom of the screen.

4.Press ENTER. The message “SAVED OK” displays.

5.14HIGH SPEED INTERFACE CONFIGURATION MENU SCREEN

NOTE

This High Speed Interface Configuration Menu screen does not display unless an optional interface module is installed: one or two Fast Ethernet Interface Modules, or High Speed Interface Module (HSIM).

The High Speed Interface Configuration Menu screen, Figure 5-21, applies to the Fast Ethernet Interface Modules and the High Speed Interface Module.

5-46 2E42-27/2E42-27R/2E43-27/2E43-27R User’s Guide