Canon H12157 manual Users in Canada

USERS IN CANADA

PRE-INSTALLATION REQUIREMENTS FOR CANON FACSIMILE EQUIPMENT

A.Location

Supply a suitable table, cabinet, or desk. See Appendix for the unit’s dimensions and weight.

B.Order Information

1.Provide only a single-line to touch-tone or rotary telephone set terminated with a standard 4-pin modular phone plug. (Touch-tone is recommended if available in your area.)

2.Order an CA11A modular jack (USOC code), which should be installed by the phone company. If the CA11A jack is not present, installation cannot occur.

3.Order a normal business line from your telephone company’s business representative. The line should be a regular voice grade line or equivalent. Use one line per unit.

DDD (DIRECT DISTANCE DIAL) LINE

or

IDDD (INTERNATIONAL DIRECT DISTANCE DIAL) LINE IF

YOU COMMUNICATE OVERSEAS

nCanon recommends an individual line following industry standards [e.g., the 2500 (Touch Tone) or 500 (Rotary/Pulse Dial) telephones]. A dedicated extension of a PBX unit without “Camp On” signals is also permissible with a fax unit. Key telephone systems are not recommended because they send non-standard signals to individual telephones for ringing and special codes, which may cause a fax error.

C.Power Requirements

The power outlet should be a three-prong grounded receptacle (Single or Duplex). It should be independent from copiers, heaters, air conditioners, or any electric equipment that is thermostatically controlled. The rated value is 120 volts and 15 amperes. The CA11A modular jack should be relatively close to the power outlet to facilitate installation.

viii Preface