Canon H12157 manual Connecting the Laser Class 2060P to Your PC

Models: H12157

1 359
Download 359 pages 3.43 Kb
Page 55
Image 55

Connecting the LASER CLASS 2060P to Your PC

Your LASER CLASS 2060P has an 8-bit, bi-directional parallel interface port that allows you to connect it to a PC. To do this, you need to purchase a Centronics-compatible parallel interface cable from your dealer.

NFor best results, use a cable that is no longer than 6.6 feet (2 meters). Canon recommends that you use a cable that complies with IEEE 1284. Contact your local authorised Canon Facsimile Dealer if you need help in selecting a cable.

Connect the LASER CLASS 2060P to your computer as follows:

1.Make sure the computer is turned off and the LASER CLASS 2060P is unplugged.

2.Connect the parallel interface cable to your LASER CLASS 2060P:

a.Align the cable connector with the interface port so their shapes match.

b.Gently press the cable connector into the port.

c.Secure the cable connector by snapping both wire clips (on the sides of the port) into the cable connector, as shown below.

3.Connect the other end of the cable to the parallel interface port on your computer in the same manner.

Setting Up Your LASER CLASS 2060P

Chapter 2

Setting Up Your LASER CLASS 2060P 2-21

Page 55
Image 55
Canon H12157 manual Connecting the Laser Class 2060P to Your PC