Canon L240 Copying Problems, Cannot receive using Error Correction Mode ECM, Cannot make copies

Toner may be low or unevenly distributed.

•Redistribute the toner inside the toner cartridge (￿p. 12-7). If the problem persists, replace the toner cartridge (￿p. 12-7).

■Cannot receive using Error Correction Mode (ECM).

The other party’s fax machine may not support CM.

•If this is the case, the document is received without ECM.

ECM may be disabled.

•Make sure ECM on your FAX is enabled (￿ECMRX, p. 14-7).

•Contact the other party to check if ECM on their fax machine is enabled.

■Errors occur frequently while receiving.

The telephone lines may be in poor condition, or you may have a bad connection.

•Lower the reception speed (￿RXSTARTSPEED, p. 14-10).

The other party’s fax machine may not be functioning properly.

•Contact the other party and have them check that their fax machine is functioning properly.

Copying Problems

■Cannot make copies.

The document may not be loaded correctly.

•Make sure the document is loaded correctly in the ADF (￿p. 4-3).

•Make sure the operation panel is closed.

The document may not meet the requirements for the FAX.

•Make sure you load documents that meet the requirements for the FAX (￿p. 4-2).

■MEMORY FULL appears in the LCD when making multiple copies.

The FAX’s memory is full.

•Print, send, or delete any documents stored in memory (￿p. 9-5) to free up space in the FAX’s memory, then start again.

The document you are copying may have too many graphics.

•If multiple pages are being copied, separate the pages into smaller stacks. If not, make the desired number of copies one at a time as needed.

For additional troubleshooting, see Printing Problems, p. 13-18.

Note

Troubleshooting

Chapter 13 Troubleshooting 13-17