Important
zBe sure to remove the clear film from the ink tank in the exact order shown in step 5, as failure to follow this step may cause the ink to leak and stain your clothes and hands.
zDo not touch the electrical contacts (G). Doing so can cause the machine to malfunction or become unable to print.
zDo not squeeze the side of ink tanks (F) as this may cause the ink to leak out and stain your clothes and hands.
zDo not
zDo not touch the open ink port (E) once the protective cap is removed, as this may prevent the ink from being ejected properly.
zInk on the removed protective cap may stain your clothes and hands.
zEnsure that all the orange tape has been peeled off along the perforation. If there remains a part of the orange tape, ink may not be ejected correctly.
5Install the ink tank.
(1)Install the ink tank into the Print Head.
Note
Refer to the guide label (A) and insert the ink tank in the correct position.
(2)Press on the 
mark on the ink tank until the ink tank snaps firmly into place.
(3)Ensure that the ink tank clicks into place and then its lamp lights red (B).
(A)
(B)
Important
Make sure to install all the ink tanks to enable printing. The machine cannot be used unless all the ink tanks are installed.
112 | Routine Maintenance | Chapter 11 |