Message | Action | |
Inner cover is open. Close the inner | If the Inner Cover is open when starting normal printing, close it before | |
cover and press [OK]. | pressing [OK] on the machine. | |
| Do not open or close the Inner Cover when printing. This may damage the | |
| machine. | |
|
| |
Some ink tanks are not installed in | Possible causes are as follows: | |
place. | z Some ink tanks are not installed in place. | |
U072 | z More than one ink tanks of the same color are installed. | |
More than one ink tank of the | Confirm that the ink tanks are installed in the appropriate positions. See | |
following color is installed. | ||
“Replacing an Ink Tank” on page 108. | ||
| ||
U071 |
| |
|
| |
The waste ink absorber is almost | Ink used for cleaning is absorbed in a waste ink absorber placed in the | |
full. Press [OK] to continue but early | machine. | |
replacement recommended. <See | Press [OK] to cancel the error so that you can continue printing. Once the | |
manual> | ||
waste ink absorber becomes completely full, printing cannot be done until | ||
| ||
| the waste ink absorber is replaced. | |
| Canon recommends to contact the Canon Customer Care Center as soon | |
| as possible.You will need to replace a particular part of the machine. | |
|
| |
The following ink tank cannot be | Possible causes are as follows: | |
recognized. | z The ink tank may not be installed properly (The lamp on the ink tank is | |
U140 | off). Install the appropriate ink tank. | |
U043 | z The ink tank may not be compatible with this machine (The lamp on the | |
| ink tank is off). Install the appropriate ink tank. See “Replacing an Ink | |
| Tank” on page 108. | |
|
| |
The following ink tank cannot be | z Ink tank errors have occurred (The lamp on the ink tank is off). | |
recognized. | Replace the ink tank. | |
U150 | ||
See “Replacing an Ink Tank” on page 108. | ||
| ||
| z The ink tank that is not supported by this machine is installed (The | |
| lamp on the ink tank is off). | |
| Install the appropriate ink tank. | |
| See “Replacing an Ink Tank” on page 108. | |
|
| |
The remaining level of the following | An ink tank that was once empty is installed. | |
ink cannot be correctly detected. | Replace the ink tank. | |
| ||
U130 | Printing under the situation may damage the Print Head. | |
| ||
| Canon shall not be liable for any machine malfunction or damage caused | |
| by refilled ink tanks. | |
| If you want to continue printing with the refilled ink tank installed, press | |
| and hold [Stop/Reset] for at least 5 seconds, and then release it. Using | |
| refilled ink tanks are memorized. | |
| * This operation will release the function for detecting the remaining ink | |
| level. | |
|
| |
Incompatible device detected. | Disconnect the camera cable, and reconnect it. | |
| Depending on the model or brand of your device, you may have to select a | |
| print mode compliant with PictBridge before connecting the camera. | |
| You may also have to turn on the camera or select Play mode manually | |
| after connecting the camera to the machine. Perform necessary | |
| operations according to the instruction manual supplied with your | |
| camera. | |
| If the error is still unresolved, there is a possibility that you are using a | |
| digital camera or digital video camcorder that is not supported by this | |
| machine. Use a digital camera or digital video camcorder compatible with | |
| this machine. | |
|
|
128 | Troubleshooting | Chapter 12 |