7-23
Cisco MGX 8220 Installation and Configuration
Release 5.0, Part Number 78-6430-03 Rev. D0, November 2003
Chapter Cable Management
Perform the following steps to install the cable management kit on the cooling module and the booster
cooling module (see Figure7-17).
Step 1 Install the two short fan panel brackets onto the sides of the cooling unit, one on each side using two
thread forming screws for each bracket.
If a rear rail is being used to mount the plenum, use the protruding flange to attach to the rail using two
thread forming screws and washer s (supplied with the cooling un it install kit). If there is limite d access,
use the procedures described under “Limited Access” section on page 7-10. Install the power and fan
cable management assembly onto the two short fan panel brackets using two screws with locking nuts
for each bracket.
Step 2 Install the cable manage ment pa nel on to the ou ter bra ck et s u sin g f our sc re ws , l ocki ng nu ts, and w ash er s
for each bracket.
Step 3 Install one or both cable suppor ts onto the MGX 8220 shelf above the c ooling module, using a number
10-32 thread forming screw for each support. Use two washers between the cable supports on the left
support only.
Figure7-17 Installation of the Cable Management Kit on the Cooling Module
Cable management
panel, attach with
10-32 screws, locking
nuts and washers
Cooling assembly or
booster assembly
Short fan panel
bracket, attach with
10-32 thread forming
screws and washers
AXIS shelf
Attach bracket to rear rail (if
present) using 10-32 thread
forming screws
Power & fan cable
management assembly,
attach with 10-32 screws
and lock nuts
Cable support,
attach with 10-32
thread forming screws
Cable support,
attach with 10-32
thread forming screws
and two washers
LH
RH
H8289
MGX 8220 shelf