3-16
Cisco MGX 8220 Installation and Configuration
Release 5.0, Part Number 78-6430-03 Rev. D0, November 2003
Chapter
TFTP User Interface
The contents of the kit are:
•ASC
•FRSM
•AUSM
•CESM
•FRASM
•IMATM
•MIB
TFTP, either through the control port or in-band ATM, is used for downloading firmware from a
workstation into the Cisco MGX 8220 modules.
The host uses the following comm a nd se quence to download the firmware:
1. tftp dest_IP_add
dest_IP_add is the IP address of the Cisco MGX 8220 shelf receiving the downloaded firmware
(via Ethernet, control port, or in-band connection).
2. tftp> bin
3. tftp> put source_file_name dest_file_name
source_file_name is the name of the firmware source file (this can be any nam e the user has chosen
to store the firmware).
dest_file_name is the nam e o f th e file to which the firmware is to b e downloaded, this must be
AXIS_ASC_1_slot#.FW for downloading to a service module, for example,
AXIS_ASC_1_9.FW for downloading firmware to the service module in slot 9.
AXIS_ASC_1_0.FW for downloading firmware to the ASC for use in any slot 5 - 14.
AXIS_ASC_ACTIVE.FW for downloading to the active ASC.
AXIS_ASC_STANDBY.FW for downloading to the standby ASC.
If the download proc es s i s di srupted for a timeou t or other such errors , restart the TFTP dow nl oad
process without resetting the Cisco MGX 8220 shelf.
If there is a hardware or system failure that requires resetting the card being do w n loaded, the firmware
must be downloaded using the backup boot procedure. This is a two step procedure.
1. Download the boot firmware.
2. Download the on-line firmware.
If a backup boot procedure becomes necessary, contact technical support for assistance.
After the firmware file h as b een tran sfer re d compl e tely and s u cces sful ly, the module should be res et fo r
the downloaded firm ware to take effect.