Cisco Systems SFS 3012R manual Securing an InfiniBand Switch Module

Chapter 3 Installing and Removing Server Switch Field Replaceable Units (FRUs)

Installing an InfiniBand Switch Module

Step 8 Tighten the screws on either side of the switch module to secure it to the chassis.

Figure 3-5 Securing an InfiniBand Switch Module

180744

Step 9 Verify that the system image on the InfiniBand switch module is consistent with the image on other cards in the chassis and update the image, if necessary. Use the show card command to determine the current image, as shown in the following example:

SFS-3012R#show card all

================================================================================

Card Information

================================================================================

admin	oper	admin	oper	oper
slot type	type	status	status	code

--------------------------------------------------------------------------------

1*	controller	controller	up	up	normal
7	fc2port2G	fc2port2G	up	up	normal
8	fc2port2G	fc2port2G	up	up	normal
14	controller	controller	up	up	standby
15	ib12port4x	ib12port4x	up	down	wrong-image
16	ib12port4x	ib12port4x	up	up	normal

================================================================================

Card Boot Information

================================================================================Pr

boot	boot	boot
slot stage	status	image

--------------------------------------------------------------------------------

1	done	success	TopspinOS-2.8.0/build068
7	done	success	TopspinOS-2.8.0/build068
8	done	success	TopspinOS-2.8.0/build068
14	done	success	TopspinOS-2.8.0/build068
15	none	none	TopspinOS-2.8.0/build060
16	done	success	TopspinOS-2.8.0/build068

SFS-3012R#

To interpret the output, examine the information for the slot in which you just installed the InfiniBand switch module. If the oper status is shown as “down” and the oper-code as “wrong-image” (as shown for slot 15 in the example), then the module needs to have its image updated.

See Chapter 4, “Viewing and Updating the Software Image” for instructions about updating the software image on the InfiniBand switch module.

Cisco SFS 3012R Multifabric Server Switch Hardware Installation Guide

3-6 OL-11187-01