MODEL: CDR1660 / CDR0860 / CDR0460 | H.264 |
| |
8.2.1.6. ALARM RECORDING |
|
|
|
User can set the ALARM RECORDING of each Channel. |
|
| |
| Click the ALARM ( | ) button of the desired | |
| channel in the RECORDING SETUP menu and you | ||
| can see the SENSOR menu like the left picture. | ||
| Or in case of using the remote controller or the front | ||
| panel buttons, highlight the ALARM ( | ) button | |
| of the desired channel using the ▲,▼,◀, ▶ buttons | ||
| and press the ENTER button. |
| |
Click the X button or press the ESC button to exit from this screen.
8.2.1.6.1. ALARM RECORDING
Select the ALARM RECORDING to either “ON” or “OFF” by clicking the left button of the mouse. Or in case of using the remote controller or the front panel buttons, highlight ALARM RECORDING and press the ENTER button and then move the cursor to the desired value using the ▲, ▼ buttons and press the ENTER button. If you set the alarm recording to ON, the
ALARM (
) button will be displayed by “O” and in case of OFF, the ALARM(
) button will be displayed by “X” in the RECORDING SETUP. The default is ON.
Click the 
button in the RECORDING SETUP menu to enable or disable all channels.
8.2.1.6.2. PRE RECORDING TIME
Refer to chapter 8.2.1.5.2. PRE RECORDING TIME on page 66.
8.2.1.6.3. POST RECORDING TIME
Refer to chapter 8.2.1.5.3. POST RECORDING TIME on page 66.
8.2.1.6.4. SENSOR INPUT TYPE
Select the sensor input type or the type of the circuit to be used with each channel by clicking the left button of the mouse. Or in case of using the remote controller or the front panel buttons, highlight SENSOR INPUT TYPE and press the ENTER button and then move the cursor to the desired value using the ▲, ▼ buttons and press the ENTER button.
Available options are normally closed (NC), normally open (NO) and not used. The default value is “NORMAL OPEN’.
8.2.2. AUDIO RECORDING
User can set the AUDIO RECORDING to either “ON” or “OFF “by clicking the left button of the mouse on the value. Or in case of using the remote controller or the front panel buttons, highlight AUDIO RECORDING and press the ENTER button and then move the cursor to the desired value using the ▲, ▼ buttons and press the ENTER button. The Default value is “OFF”
“ON” indicates that the audio will be recorded along with the Video signal.
“OFF” indicates that the no audio will be recorded along with the Video signal.
67
