Site requirements

Operating environment

Relative humidity: 20% to 80% non-condensing

Temperature: 60° F to 95° F (15° C to 35° C)

Electrical requirements

The external power supply is rated at 100-240 VAC, 50-60 Hz, 1.8 amp. (It adjusts to any power within this range.)

Single phase, 3-wire, grounded receptacle only.

Physical requirements

• The printer weighs less than 11.5 pounds (5.3 kg). The weight

depends on the supplies and options installed.

• Printer dimensions are 21.5 inches (546 mm) long and 7.8

inches (198 mm) wide. The 100-card input hopper is 9.5 inches

(241 mm) high and the 200-card hopper is 11.9 inches (302 mm)

high.

2”

7.8”

10.5” (for cover)

1”

11.9”

• The clearance required 1 inch (25 mm) at the back, 2 inches (5

cm) on the left side, and 10.5 inches (267 mm) above the printer

latch to open the cover.

Do not use the printer in a dirty environment. Do not use the printer in a closed compartment. Do not block air flow around the printer.

9.5”

21.5”

Page 22

Page 27
Image 27
Datacard Group SP Series manual Site requirements, Electrical requirements