Dell E05S001 owner manual Installing the Integrated Storage Controller Card

Installing the Integrated Storage Controller Card

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.

2Open the system. See "Opening the System" on page 76.

3Remove the cooling shroud. See "Removing the Cooling Shroud" on page 88.

4Remove the cooling fan assembly. See "Removing the Cooling Fan Assembly" on page 102.

5Hold the card by its edges and angle it between the alignment guides on riser 1 until it is fully seated. See Figure 3-1.

6Connect the SAS data cables to the integrated storage controller card. See Figure 3-19.

NOTE: Ensure that you connect the cable according to the connector labels on the cable. The cable does not function properly if reversed.

7If applicable, connect the RAID battery cable. See Figure 3-20.

8Route the SAS data cable through the channel on the inner side of the chassis.

9Attach the cable labeled "SAS A" to SAS A connector on the backplane, and attach the cable labeled "SAS B" to SAS B connector on the backplane. See Figure 3-19.

10Replace the cooling fan assembly. See "Installing the Cooling Fan Assembly" on page 104.

11Replace the cooling shroud. See "Installing the Cooling Shroud" on page 89.

12Close the system. See "Closing the System" on page 77.

13Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

Installing System Components

117