Dell E05S001 VFlash Media Optional, Removing a VFlash Media Card, Installing a VFlash Media Card

3Remove the plastic filler plug for the iDRAC6 Enterprise port from the system back panel. See Figure 1-3.

4Align the front edge of the card with the two plastic retention standoffs next to the iDRAC6 connector on the system board, and lower the card into place. See Figure 3-21 and Figure 6-1.

When the front of the card is fully seated, the plastic standoffs snap over the edge of the card.

5If applicable, connect the Ethernet cable from the iDRAC6 Enterprise Card connector on the system back panel. See Figure 1-3.

6Close the system. See "Closing the System" on page 77.

7Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

8Enter the iDRAC6 configuration utility and set up the Ethernet mode. See "iDRAC6 Configuration Utility" on page 71.

VFlash Media (Optional)

The VFlash media card is a Secure Digital (SD) card that plugs into the optional iDRAC6 Enterprise card at the back corner of the system.

Removing a VFlash Media Card

To remove the VFlash media, push inward on the card to release it, and pull the card from the card slot.

Installing a VFlash Media Card

1Locate the VFlash media slot at the back corner of the system. See Figure 1-3.

2With the label side facing up, insert the contact-pin end of the SD card into the card slot on the module.

NOTE: The slot is keyed to ensure correct insertion of the card.

3Press inward on the card to lock it into the slot.

122

Installing System Components