Dell E05S001 owner manual Removing LCD Status Messages

Removing LCD Status Messages

For faults associated with sensors, such as temperature, voltage, fans, and so on, the LCD message is automatically removed when that sensor returns to a normal state. For other faults, you must take action to remove the message from the display:

•Clear the SEL—You can perform this task remotely, but you will lose the event history for the system.

•Power cycle—Turn off the system and disconnect it from the electrical outlet; wait approximately 10 seconds, reconnect the power cable, and restart the system.

NOTE: The following LCD status messages are displayed in the Simple format. See "Setup Menu" on page 16 to select the format in which the messages are displayed.

Table 1-1. LCD Status Messages

Code	Text	Causes	Corrective Actions
E1000	Failsafe	Check the system event log	Remove AC power to the
	voltage	for critical failure events.	system for 10 seconds and
	error.		restart the system.
	Contact		If the problem persists,
	support.
			see "Getting Help" on
			page 185.
E1114	Ambient Temp	Ambient temperature	See "Troubleshooting
	exceeds	reached a point outside the	System Cooling
	allowed	allowed range.	Problems" on page 157.
	range.

E1116 Memory	Memory exceeded allowable
disabled,	temperature and has been
temp above	disabled to prevent damage
range. Power	to the components.
cycle AC.

Remove AC power to the system for 10 seconds and restart the system.

See "Troubleshooting System Cooling Problems" on page 157. If the problem persists, see "Getting Help" on

page 185.

About Your System

23