Dell E05S Alert! Node, Interleaving, Disabled! Memory, Does not support, Alert! Power, Redundant

Message	Causes	Corrective Actions
Alert! Node	The memory configuration	Ensure that the memory
Interleaving	has changed (for example, a	modules are installed in a
disabled! Memory	memory module has failed)	configuration that supports
configuration	so that node interleaving	node interleaving. Check
does not support	cannot be supported. The	other system messages for
Node	system will run but without	additional information for
Interleaving.	node interleaving.	possible causes. For memory
		configuration information,
		see "General Memory
		Module Installation
		Guidelines" on page 93. If
		the problem persists, see
		"Troubleshooting System
		Memory" on page 159.
Alert! Power	The system configuration of	If any system components
required exceeds	processor(s), memory	were just upgraded, return
PSU wattage.	modules, and expansion	the system to the previous
Check PSU and	cards may not be supported	configuration. If the system
system	by the power supplies.	boots without this warning,
configuration.		then the replaced
Alert!		component(s) are not
		supported with this power
Continuing
		supply. If Energy Smart
system boot
		power supplies are installed,
accepts the risk
		replace them with the High
that system may
		Output power supplies to use
power down
		the components. See "Power
without warning.
		Supplies" on page 85.
Alert! Redundant	Redundant memory was	Check the memory modules
memory disabled!	enabled in the system setup	for failure. See
Memory	program, but the current	"Troubleshooting System
configuration	configuration does not	Memory" on page 159. Reset
does not support	support redundant memory.	the memory setting, if
redundant	A memory module may be	appropriate. See "Using the
memory.	faulty.	System Setup Program and
		UEFI Boot Manager" on
		page 53.

About Your System

39