
Installing a Power Supply
1Verify that the power supplies are the same type and have the same maximum output power.
NOTE: The maximum output power (shown in watts) is listed on the power supply label.
2If applicable, remove the power supply blank. See "Removing the Power Supply Blank" on page 87.
3Slide the new power supply into the chassis until the power supply is fully seated and the release latch snaps into place. See Figure
NOTE: If you unlatched the cable management arm in step 1 of the previous procedure, relatch it. For information about the cable management arm, see the system’s rack documentation.
4Connect the power cable to the power supply and plug the cable into a power outlet.
CAUTION: When connecting the power cable, secure the cable with the Velcro strap.
NOTE: When installing,
Removing the Power Supply Blank
If you are installing a power supply, remove the power supply blank by pulling outward on the blank.
CAUTION: To ensure proper system cooling, the power supply blank must be installed in power supply bay PS2 in a
Installing the Power Supply Blank
NOTE: Install the power supply blank only in power supply bay 2.
To install the power supply blank, align the blank with the power supply bay and insert the blank into the chassis until it clicks into place.
Installing System Components
87