Dell E05S001 owner manual Control Panel Assembly, Removing the Control Panel Display Module

Control Panel Assembly

Removing the Control Panel Display Module

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1If installed, remove the front bezel. See "Removing the Front Bezel" on page 75.

2Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.

3Open the system. See "Opening the System" on page 76.

4Disconnect the display module cable from the control panel board. See Figure 3-29.

NOTE: Using a small screwdriver or a knife raise the edges of the cable socket and release the cable clamp.

5Using a knife or a small flat-blade screwdriver, insert the blade beneath the front panel of the display and slide the blade across the bottom to lift the panel outward. See Figure 3-29.

6Bend the panel upward to access to the mounting screws.

7Using a T10 Torx driver, remove the two screws that secure the display module to the system.

8Remove the display module from the chassis cutout.

Installing System Components

139