Dell E05S001 owner manual Sata Settings Screen, Boot Settings Screen

SATA Settings Screen

Option	Description
Embedded SATA	ATA Mode enables the integrated SATA controller. Off
(Off default)	disables the controller.
Port A	Auto enables BIOS support for the device attached to
(Off default)	SATA port A. Off disables BIOS support for the device.

Boot Settings Screen

Option	Description
Boot Mode	CAUTION: Switching the boot mode could prevent
(BIOS default)	the system from booting if the operating system was
	not installed in the same boot mode.
	If the operating system supports Unified Extensible
	Firmware Interface, you can set this option to UEFI.
	Setting this field to BIOS allows compatibility with non-
	UEFI operating systems.
	NOTE: Setting this field to UEFI disables the Boot
	Sequence, Hard-Disk Drive Sequence, and USB Flash Drive
	Emulation Type fields.
Boot Sequence	If Boot Mode is set to BIOS, this field tells the system
	where the operating system files needed for startup are
	located. If Boot Mode is set to UEFI, you can access the
	UEFI boot manager utility by rebooting the system and
	pressing <F11> when prompted to do so.
Hard-Disk Drive	Determines the order in which the BIOS attempts to
Sequence	boot from hard drives in the system during system
	startup.
USB Flash Drive	Determines the emulation type for a USB flash drive. If
Emulation Type	Boot Mode is set to UEFI, this field is disabled.
Boot Sequence Retry	If this field is enabled and the system has failed to boot,
(Disabled default)	the system reattempts to boot after 30 seconds.

Using the System Setup Program and UEFI Boot Manager

59