Dell E05S001 owner manual Power Distribution Board, Installing the SAS Backplane

Installing the SAS Backplane

1Align the slots on the SAS backplane with the tabs on the front-chassis assembly.

2Slide down the SAS backplane until the blue release tabs snap into place.

3Connect the SAS data cable(s) and power cable to the backplane. See Figure 3-27.

4Install the hard drives in their original locations. See "Installing a Hard- Drive Carrier" on page 81.

5If required, route the power/data cables along the chassis wall. See "Front- Chassis Assembly" on page 90.

6Replace the cooling shroud. See "Installing the Cooling Shroud" on page 89.

7Close the system. See "Closing the System" on page 77.

8Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

9If applicable, replace the front bezel. See "Installing the Front Bezel" on page 75.

Power Distribution Board

Removing the Power Distribution Board

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.

2Remove the power supplies from the system. See "Removing a Power Supply" on page 86.

3Open the system. See "Opening the System" on page 76.

Installing System Components

135