Dialogue Tech NANO-PV-D510A Single RS-232 Cable w/o Bracket, Single RS-232 Cable Installation

NANO-PV-D510A User Manual

PS/2 connectors. The keyboard PS/2 connector and mouse PS/2 connector are

both marked. Please make sure the keyboard and mouse are connected to the

correct PS/2 connector.

4.6.4 Single RS-232 Cable (w/o Bracket)

The single RS-232 cable consists of one serial port connector attached to a serial communications cable that is then attached to a D-sub 9 male connector. To install the single RS-232 cable, please follow the steps below.

Step 1: Locate the connector. The location of the RS-232 connector is shown in Chapter 3.

Step 2: Insert the cable connector. Insert the connector into the serial port box header.

See Figure 4-15. A key on the front of the cable connectors ensures the

connector can only be installed in one direction.

Figure 4-15: Single RS-232 Cable Installation

Step 3: Secure the bracket. The single RS-232 connector has two retention screws

that must be secured to a chassis or bracket.

Page 54