Emerson 4015 installation instructions IM584000300

Installation Instructions	IM584000300
Spec. No. 584000300 (Model 4015-X003)	Issue AB, April 3, 2013

e)Secure the rear mounting brackets to the power and control sub-rack with the furnished hardware (hardware is installed from inside the sub-rack, the rear mounting brackets have captive fasteners).

3)If furnished, the battery tray(s) is typically installed at the bottom of the IT rack due to the weight of the batteries.

Note: Only install the battery tray(s) at this time. Battery sub-trays (with batteries) will be installed in the “Making Electrical Connections” section.

Note: The system can consist of 0-5 battery tray(s).

Note: Battery cables from the battery tray(s) can enter the power and control sub-rack from either the top or bottom of the power and control sub-rack. Note that a space is required between the power and control sub-rack and battery tray to allow the cables to enter from the bottom.

a)Secure the rear mounting brackets to the IT rack with the furnished cage nuts and screws.

b)Slide the battery tray into the front of the IT rack until it is in position (with the bottom of the sub-rack resting on the angles of the rear mounting brackets).

c)Secure the front mounting flanges to the IT rack with the furnished cage nuts and screws.

d)Secure the rear mounting brackets to the battery tray with the furnished hardware (hardware is installed from inside the battery tray, the rear mounting brackets have captive fasteners).

e)Repeat this procedure if other battery tray(s) are furnished.

Chapter 2. Installing the System Page 11

This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy

Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.