IM584000300 | Installation Instructions |
Issue AB, April 3, 2013 | Spec. No. 584000300 (Model |
|
|
Power and Control
Battery Tray Alarm / Control Connections - 2 or More Trays
Internal/External Battery Tray Control/Alarm Connectors
(If an internal or external battery tray is not connected, MUST have termination plugs installed.) (Use either connector.)
Extension Control/Alarm Cable (P/N 554715) (56”)
Rear
Battery Tray
Control/Alarm Daisy Chain Cable (P/N 553614)
Battery Tray
Battery Tray
Rear
Battery Tray
Control/Alarm
Harness
Rear
Battery Tray
Control/Alarm
Harness
1. Remove a termination plug from one of the connectors (either one) located on the rear of the power and control
2. Plug the extension control/alarm cable into the connector the termination plug was removed from.
3. Connect the other end of the extension control/alarm cable into the end of the battery tray control/alarm daisy chain cable.
4. Plug the center connector of the battery tray control/alarm daisy chain cable into the battery tray control/harness of the first battery tray.
5. Plug the remaining end of the battery tray control/alarm daisy chain cable into the battery tray control/harness of the second battery tray.
Figure 3-7 (cont’d from previous page)
Internal Battery Tray Interconnections
Page 24 | Chapter 3. Making Electrical Connections |
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
