Emerson NGA 2000 TO2 instruction manual Multi Component Display, Select Status… Tags Off LCDReset

Instruction Manual

760008-A September 2001

Model NGA 2000 TO2

c. Multi Component Display	to five using the following steps to change
	from the single component display to the
If other analyzer modules are connected	multi component display as follows:
to the Platform, it is possible to display up

TO2
37.50						ppm O2
0.00			Range: 3				50.00
Electrolyte level:			OK
Temp current:			263 uA	0.0			600
Range:		3
Sensor Current:		0.0500 uA		0.0000			100.0000
Display	Status…		Main…		Channel		BasicCal
> 37.50			TO2
				0.00	[3]			50.00
		ppm O2
2.50		MLT/CH1
				0.000		[2]	5.00
		% CO2
95.00		MLT/CH2
				0.00	[2]		250.00
		ppm CO
150.0
		MLTCH3
				0.00		[2] F.S.	150.00
		Ppm NO
Select	Status…		Tags Off				LCDReset
MLT/CH1/R2
2.50							2
						% CO

From the single channel display (Measure) press F1 (Display) to change to the Multi Component Display of all other installed Analyzer Modules.

Note: Changing to the multi component dis- play can be done from each single compo- nent display.

Each bargraph shows the start and end of the range for the respective channel. The number in parentheses indicates the number of the selected range for that channel. (F.S. = full scale)

Note: Display may look different depending on installed analyzers.

Use the F3 key (Tags Off) to turn the ana- lyzer tags on or off.

To select a single channel display in the multi channel display, enable the select symbol (>) by pressing the F1 key of the ↓ key.

Then use the ↓ or ↑ key to select the line for the desired channel. When the desired chan- nel is marked, select it for single component display by pressing the F1 key.

0.00

Temperature:

Maintenance-Requests:

Any-alarms:

Operation:

Display Status…

Range: 2 5.00

37.0C 0.0 No

No

Ready

Main… Channel BasicCal

Figure 3-12. Multi Component Display

3-10 Operation Rosemount Analytical Inc. A Division of Emerson Process Management