Model NGA 2000 TO2

Instruction Manual

760008-A September 2001

d.Linearization

Linearization is only performed when the sensor is changed. See section 4-3 be- low.

TO2

37.50 ppm

-- Analyzer Module Setup and Controls --

Calibration…

Alarms…

Ranges…

Linearization…

Measurement display configuration…

Concentration measurement…

Flow measurement…

Temperature measurement…

Measure

Status…

Back…

TO2

37.50 ppm

 

-- Measurement Display Configuration --

e. Measurement Display Configuration

Move the cursor to the “Measurement display configuration…” line and press the key. The “Measurement Display Configuration” menu will be displayed.

The first two lines allow for setting the con- centration value displayed precision and number of digits.

Displayed concentration digits: Digits after decimal point:

Module identification tag:

Signal on mini-bargraph – 1: Signal on mini-bargraph – 2: Signal on mini-bargraph – 3: Signal on mini-bargraph – 4:

Measure

6

2

TO2

Electrolyte level Temp current Range Sensor current

Back…

The “Module identification tag:” line set the displayed neumonic for the analyzer on all display screens. Select the line and press the

key to change the values using the and keys to select a digit and then the and keys to change the value. The values will scroll through all numbers and upper and lowercase letters.

Figure 3-20. Measurement Display Configuration

The “Signal on mini-bargraph” lines are used to set various status values that can display on the four lines available on the single component (Measure) display. Se-

lect a line and press the key. To change the value use the and keys. The val- ues will scroll through the allowable se- lections as follows:

Electrolyte level

Displays “OK” or “Low.”

Range

Displays the range number from 1 to 4.

Sample flow

Displays the sample flow rate in ml/min with a bargraph.

Sensor current

Displays the sensor current in uA with a bargraph.

Temp. current

Displays the heater current in uA with a bargraph.

Sensor temp.

Displays the sensor temperature in °C with a bargraph.

Validity

Not functional on the TO2.

Operation status

Not functional on the TO2.

Rosemount Analytical Inc. A Division of Emerson Process Management

Operation 3-19

Page 43
Image 43
Emerson NGA 2000 TO2 Linearization, Measurement Display Configuration, Measurement display configuration…