Model NGA 2000 TO2
Instruction Manual
a.System SIO
This menu provides submenus for setting up the output configurations of the SIO signals. The SIO board can contain 2 to 8 analog outputs, a serial interface (RS232 or RS485), and three relay outputs. Gen-
eral configuration of the SIO board is contained in its own manual.
If the SIO board is installed in the ana- lyzer, the line “Module installed:” must be set to “Yes.”
Main Menu
↓
Analyzer and I/O expert controls and setup…
TO2 | 37.50 ppm |
|
Analyzer module controls…
System & network I/O module controls…
Analyzer module setup…
System & network I/O module setup…
(Note: Controls & setup are identical for MLT/FID)
| Measure |
| Channel |
| Back… |
|
|
|
|
|
|
|
|
|
|
| TO2 |
|
|
|
| 37.50 ppm | |
System SIO module…
System DIO module…
Measure | <<< | Back… | >>> |
TO2 |
| 37.50 ppm | |
| |||
Analog output setup… |
|
| |
Serial interface setup… |
|
| |
Relay outputs setup… |
|
| |
Module installed: |
| Yes | |
|
|
|
|
Measure |
| Back… |
|
Select a line with the ↑ or ↓ keys.
Select the variable or change to the submenu with the ↵ or → keys.
Select the variable parameter with the ↑ or ↓ keys.
Confirm the new value with the Enter ↵ key or cancel and return to the last value with the F2 key.
The “Module installed:” parameter is set to “Yes” or “No” depending on whenter or not the SIO module is installed.
Figure 3-25. System SIO Module
Rosemount Analytical Inc. A Division of Emerson Process Management | Operation |
