Enterasys Networks manual Matrix X16-C Chassis Setup, Required Tools

3

Matrix X16-C Chassis Setup

This chapter describes the following:

For information about:	Refer to page ...
Required Tools	3-1
Unpacking the Matrix X16-C Chassis	3-2
Setting Up the Matrix X16-C Chassis	3-5
Installing and Removing a Power Supply	3-13
Installing and Removing a Fan Tray	3-18
Installing and Removing Modules	3-20
Attaching Cables, Installing Compact Flash Card and DIMM Upgrade Kit	3-26
Installing the Optional Cable Management Kit	3-38
Powering Up the Matrix X16-C Chassis	3-41
LEDs and Reset Button	3-42
First-Time Quick Configuration	3-47

Required Tools

Installation equipment needed includes:

• Box cutter

• Phillips screwdriver

• Flat blade screwdriver

Electrical Hazard: Only qualified personnel should install or service this unit.

Riesgo Eléctrico: Solamente personal calificado debe realizar procedimientos de instalacion.

Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und qualifiziertes Personal vorgenommen werden.

A box cutter is required to cut the shipping straps. A Phillips screwdriver is needed to install the unit in a 19‐inch (48.26‐centimeter) equipment rack and to install the optional Cable Management Kit (refer to “Optional Cable Management Kit” on page 3‐37 for more information). A flat blade screwdriver is used to tighten and loosen captive screws. Refer to Chapter 2 for guidelines that must be followed to install the Matrix X16‐C chassis.

Matrix X16-C Chassis Installation Guide 3-1