Enterasys Networks X16-C manual Installing an XFP/SFP Module

Attaching Cables, Installing Compact Flash Card and DIMM Upgrade Kit

4.After completing all module installation, be sure that you leave no slots uncovered. Failure to seal any empty slots with the provided coverplates may hamper power cooling of the chassis and its components.

5.To remove an installed FM, first disconnect any cabling and perform the installation steps in reverse.

Attaching Cables, Installing Compact Flash Card and DIMM Upgrade Kit

Matrix X Router modules provide the following interfaces for cable and Flash card connections:

•IOM: XFP or SFP optical ports

•CM: Two serial RJ45 ports for Ethernet and Console (COM) connections

•CM: USB port

•CM: IDE port for connection to Type I Compact Flash card

Matrix X Router IOMs support XFP (10‐Gigabit Small Form‐Factor Pluggable) and SFP (Small Form‐Factor Pluggable) hot‐swappable optical transceivers for 10‐ and 1‐Gigabit and 10/100/1000 Ethernet connections.

Installing an XFP/SFP Module

This section describes how to install an XFP or SFP optical transceiver. For XFP/SFP specifications, refer to Appendix A, Specifications and Regulatory Compliance.

Caution: Carefully follow the instructions in this manual to avoid damaging the XFP/SPF and IOM module.

The XFP/SPF and IOM module are sensitive to static discharges. Use an antistatic wrist strap and observe all static precautions during this procedure. Failure to do so could result in damage to the XFP/SPF and IOM module. Always leave the XFP/SPF and IOM module in the antistatic bag or an equivalent antistatic container when not installed.

Precaución: Siga las instrucciones del manual para no dañar el XFP/SPF o la módulo IOM, puesto que son muy sensible a las descargas de electricidad estática. Utilice la pulsera antiestática y tome todas las precauciones necesarias durante este procedimiento. Si no lo hace, podría dañar el XFP/SPF y la módulo IOM. Mientras no esté instalado, mantenga el XFP/SPF y la módulo IOM en su bolsa antiestática o en cualquier otro recipiente antiestático.

Warning: Fiber-optic XFP/SFPs use Class 1 lasers. Do not use optical instruments to view the laser output. The use of optical instruments to view laser output increases eye hazard. When viewing the output optical port, power must be removed from the network adapter. Advertencia: Los XFP/SFPs de fibra optica usan lasers de clase 1. No se debe usar instrumentos opticos para ver la potencia laser. El uso de los instrumentos opticos para ver la potencia laser incrementa el riesgo a los ojos. Cuando vean el puerto de la potencia optica, la corriente debe ser removida del adaptador de la red.

Warnhinweis: XFP/SFPs mit Fiber-Optik Technologie benutzen Laser der Klasse 1. Benutzen sie keinesfalls optische Hilfsmittel, um die Funktion des Lasers zu überprüfen. Solche Hilfsmittel erhöhen die Gefahr von Sehschäden. Wenn sie den optischen Port überprüfen möchten stellen Sie sicher, dass die Komponente von der Spannungsversorgung getrennt ist.

3-26 Matrix X16-C Chassis Setup