3.Gently push the SIMM into the socket and then tilt it left until it is vertical.
The SIMM should snap into place between the tabs and the retaining posts. If it does not go in smoothly, do not force it; pull it all the way out and try again.
Make sure the SIMM is fully inserted into the socket and that the pins on the retaining posts extend through the holes in both ends.
4.Repeat steps 2 and 3 for each SIMM you want to install.
5.Set the appropriate main system board jumpers to indicate the total amount of memory you now have. See “Jumper Settings” on page
6.Reinstall the memory card as described on page
Installing and Removing Options