8.Locate one of the power supply cables (labelled P1 through P5) in the clasp on the left side of the subassembly. (You can use any one that is available.) Align the notched corners on the cable connector and the socket on the back of the drive, as shown below. Then push in the connector.
9.Locate the appropriate drive cable for the drive. If you installed a diskette or tape drive, go to step 10. If you installed a hard disk drive, go to step 12.
10.If you are connecting diskette drive A, use the connector labeled FDD1 on the end of the diskette drive cable. If you are connecting diskette drive B, use the middle connector, labeled FDD2. If you are connecting a tape drive, use the cable connector labeled TAPE DRIVE ONLY.
Installing and Removing Drives |