Setting a New Password

If you have forgotten your current power-on password and want to set a new one, follow these steps:

1.Turn off the computer. Then follow the instructions under “Changing the Jumper Settings” in Chapter 6 to disable the password function by setting jumper JP5 to position A.

2.Insert the Reference diskette in drive A and turn on the computer. You do not see the key prompt.

3.When the Operation Menu appears, highlight Setup and press [Enter. Then follow the instructions under “Setting the Power-on Password” in Chapter 2 to enter a new password.

Save your password setting and highlight

**EXIT AND SAVE * * when you leave Setup.

4.After you exit Setup, you see this message:

TURN OFF POWER AND CORRECT JUMPER

SETTING TO ENABLE PASSWORD CHECKING

5.Remove the Reference diskette and turn off the computer. Then follow the instructions under “Changing the Jumper Settings” in Chapter 6 to enable the password function by setting jumper JP5 to position B.

6.If you do not have a hard disk, insert the system diskette in drive A. Turn on the computer. You see the key prompt (@mu). If you enabled network server mode, you do not see the key prompt. Enter your new password to access the system.

Memorize your new password or write it down and keep it in a safe place. If you forget the password you enter now, you may have to repeat the procedure above.

Troubleshooting B-13