7.If your hard disk does not match one of the drive types listed in the Hard disk drive types table, highlight User defined and press [Enter. You see the following:
Number of cylinders 000
The same parameter is highlighted on the submenu above. Enter the correct number of cylinders and press IEnter
The information for Number of cylinders is automatically updated on the submenu above and you see the next parameter, Number of heads. Enter the correct number of read/write heads for the hard disk and press [Enter.
Follow this same procedure for each remaining item in the settings list (the number of sectors, the precompensation cylinder, and the landing zone).
If you enter a parameter incorrectly, press ? or L to highlight the parameter and then enter it again.
The Setup program does not allow you to enter the total storage capacity; it calculates the storage capacity based on what you enter for the number of cylinders, heads, and sectors.
After you type the landing zone number and press [Enter, the cursor block returns to the Drive submenu heading.
8.If you want to change the hard disk type for another drive, press + or t and return to step 4.
9.When the hard disk drive settings are correct, press 1‘ to move the cursor block into the top submenu. Highlight
**SAVE SETTINGS ** and press m to save your hard disk drive configuration.
Running the Setup Program