2.Insert the Reference diskette in drive A and turn on the computer. You do not see the key prompt.

3.When the Operation Menu appears, highlight Setup and press (Enter. Then see “Setting the Power-on Password” in Chapter 2 and follow the instructions to enter a new password. However, when you see the prompt to enter a password, press m immediately. This clears the existing password.

Be sure to save the password setting and highlight

**EXIT AND SAVE ** when you leave Setup.

4.Remove the Reference diskette and turn off the computer. Then follow the instructions under “Changing the Jumper Settings” in Chapter 6 to enable the password function by setting jumper JP5 to position B.

5.If you do not have a hard disk, insert the system diskette in drive A. Turn on the computer again. You do not see the key prompt and the computer loads the operating system.

Later, if you want to create a power-on password, run Setup and enter a password. The jumper is already in the correct position.

Disabling the password function

If you do not want to use a power-on password anymore, you can disable the password function. However, your current password is stored. If you want to be able to easily set a new password later, follow the instructions in “Disabling an existing password,” above.

To disable the password function, follow the instructions under “Changing the Jumper Settings” in Chapter 6 to change the setting of jumper JP5 to position A.

B-12 Troubleshooting