Confidential
[Details for ②]
•n indicates the number of bar code data, and the printer processes n bytes from the next character data as bar code data.
•If n is outside of the specified range, the printer stops command processing and processes the following data as normal data.
[Details in standard mode]
•If d is outside of the specified range, the printer only feeds paper and processes the following data as normal data.
•If the horizontal size exceeds printing area, the printer only feeds the paper.
•This command feeds as much paper as is required to print the bar code, regardless of the line spacing specified by ESC 2 or ESC 3.
•This command is enabled only when no data exists in the print buffer. When data exists in the print buffer, the printer processes the data following m as normal data.
•After printing bar code, this command sets the print position to the beginning of the line.
•This command is not affected by print modes (emphasized,
[Details in page mode]
•This command develops bar code data in the print buffer, but does not print it. After processing bar code data, this command moves the print position to the right side dot of the bar code.
•If d is out of the specified range, the printer stops command processing and processes the following data as normal data. In this case the data buffer position does not change.
•If bar code width exceeds the printing area, the printer does not print the bar code but moves the data buffer position to the left side out of the printing area.
•Refer to Figure 3.12.3 for bar code data buffer position.
When CODE93 (m = 72) is used:
•The printer prints an HRI character (
) as start character at the beginning of the HRI character string.
•The printer prints an HRI character (
) as a stop character at the end of the HRI character string.
EPSON | TITLE |
| SHEET | NO. |
|
| REVISION |
|
| ||
| Specification |
|
|
| |
|
| NEXT | SHEET | ||
| (STANDARD) | B | |||
|
|
|
| 139 | 138 |
