Confidential
EPSON
TITLE SHEET
REVISION NO.
SHEETNEXT
18 17
TM-T88III series
Specification
(STANDARD) B
NOTES: 1. A prefix “n” to signal names refers to “L” active signals. To the host provided with none of
the signal lines listed above, both-way communication fails.
2. For interfacing, signal lines shall use twisted pair cables with the return sides connected
to signal ground level.
3. Interfacing conditions shall be all based on the TTL level to meet the characteristics
described below. In addition, both rise time and fall time of each signal shall be
0.5 µs or less.
4. Data transmission shall not ignore the signal nAck or Busy. An attempt to transmit data
with either signal, nAck or Busy, ignored can cause lost data. (Data trans missions to
the printer shall be made after verifying the nAck signal or while the Busy signal is at the
“L” level.)
5. Interface cables shall be as minimum required short in length as possible.
2.1.2.4 Electrical Characteristics
DC Characteristics (Except Logic-H, +5 V signals)
Specifications
Characteristics Symbol
Min Max
Conditions
Output HIGH voltage VOH *2.4 V 5.5 V *IOH=0.32 mA
Output LOW voltage VOL -0.5 V *0.4 V *IOL=-12 mA
Output HIGH current IOH 0.32 mA - VOH=2.4 V
Output LOW current IOL -12 mA - VOL=0.4 V
Input HIGH voltage VIH 2.0 V -
Input LOW voltage VIL - 0.8 V
Input HIGH current IIH - -0.32 mA VIH=2.0 V
Input LOW current IIL - 12 mA VIL=0.8 V
Logic-H Signal Sender Characteristics
Specifications
Characteristics Symbol
Min Max
Conditions
Output HIGH voltage
Output LOW voltage
VOH
VOL
3.0 V
-
5.5 V
2.0 V
While the power is OFF
+5 V Signal Sender Characteristics
Specifications
Characteristics Symbol
Min Max
Conditions
Output HIGH voltage VOH *2.4 V 5.5 V *IOH=0.32 mA
Output LOW voltage VOL - - ** While the power is OFF
Output HIGH current IOH - 0.32 mA VOH=2.4 V
Output LOW current IOL - ** - While the power is OFF
** No guarantee is offered to VOL and IOL while the power is OFF.