Epson T88III specifications Autocutter, Paper Roll Supply Device, Paper Specification

Confidential

1.3 Autocutter

Partial cut: Cutting with one point left uncut

NOTE: To prevent dot displacement, after cutting, paper must be fed approximately 1 mm {14/360"} or more before printing.

1.4 Paper Roll Supply Device

1)	Supply method:	Drop-in paper roll
2)	Near-end sensor:
	a) Detection method:	Microswitch
	b) Paper roll spool diameter: Inside:		12 mm {0.47"}
		Outside:	18 mm {0.71"}

c) Near-end adjustment:

Can be adjusted by changing the position of the adjusting screw.

Fixed position #1 (approximately 23 mm {0.9"}) #2 (approximately 27 mm {1.06"})

NOTE: You can use a command to stop printing upon detection of a paper near-end.

1.5Paper Specification

1)	Paper type:	Specified thermal paper
2)	Form:	Paper roll
3)	Paper width:	79.5 ± 0.5 mm {3.13 ± 0.02"}
4)	Paper roll size:	Roll diameter:	Maximum 83 mm {3.26"}
		Take-up paper roll width: 80 +0.5/–1.0 mm {3.15+0.02/–0.04"}
5)	Specified paper:	Specified thermal roll paper:
		NTP080-80
		[Original paper: TF50KS-E Nippon Paper Industries Co., Ltd.]
		Packaged roll paper:
		[Original paper: PD160R (Oji Paper Mfg. Co., Ltd.)]
		In Japan: Nakagawa Manufacturing Co., Ltd.
		In U.S.A.: Nakagawa Mfg. (USA) Inc.
		In Europe: Nakagawa Mfg. (Europe) GmbH
		In Southeast Asia: N.A.K. Mfg. (Malaysia) SDN BHD
		The following paper can be used instead of the specified paper above:
		Original paper: PD190R (Oji Paper Mfg. Co., Ltd.)
			P350(F380), P310, P300
			(Kanzaki Specialty Papers, Inc. (U.S.A.))
			AF50KS-E (Jujo Thermal Oy (Finland))
6)	Paper roll spool diameter:	Inside:	12 mm {0.47"}
		Outside:	18 mm {0.71"}

NOTE: Paper must not be pasted to the paper roll spool.

TITLE

TM-T88IIIseries

SHEET	NO.
REVISION

EPSON Specification (STANDARD)

B	NEXT	SHEET
	5	4