Epson T88III specifications Table C.1 Adjustment Positions, Figure C.1 Near-end Adjusting Position

Confidential

APPENDIX C: ADJUSTING THE PAPER ROLL NEAR-END SENSOR LOCATION

The remaining detectable amount of paper on the paper roll varies with the inside and outside diameters of the paper core. The minimum detectable amount of paper on the paper roll can be set using the following method:

1)The inside diameter of the paper spool should be 12mm {0.47"} and the outside diameter of the paper spool should be 18mm {0.71"}. Specified thermal paper should be used.

2)Loosen the adjusting screw that holds the paper near-end sensor and set the top of the positioning plate to the appropriate adjustment value and tighten the adjusting screw.

Adjust the positioning plate to #1 if the outside diameter of a paper roll to be used is 18mm.

Adjust the positioning plate to #2 if the outside diameter of a paper roll to be used is more than 18 mm.

Table C.1	Adjustment Positions
Adjustment Position Number	Specified Thermal Paper
	Dimension of A
#1	Approximately 23 mm {0.97"}
#2	Approximately 27 mm {1.06"}

Position detecting Part

Figure C.1 Near-end Adjusting Position

NOTES: 1. Since dimension A in the table is a calculated value, there may be some variations depending on the printer.

2. Be sure that the adjustable slider operates smoothly after you finish the adjustment.

TITLE

TM-T88IIIseries

SHEET	NO.
REVISION

EPSON Specification (STANDARD)

B	NEXT	SHEET
	App.6	App.5