Epson T88III specifications ESC 3 n, ESC 2 , GS P

Confidential

ESC 3 n

[Name]	Set line spacing
[Format]	ASCII	ESC	3	n
	Hex	1B	33	n
	Decimal	27	51	n
[Range]	0 ≤ n ≤ 255

[Description] Sets the line spacing to [n ⋅ vertical or horizontal motion unit].

[Details]	• The line spacing can be set independently in standard mode and in page mode.
	• The horizontal and vertical motion unit are specified by GS P. Changing the horizontal or
	vertical motion unit does not affect the current line spacing.
	• The GS P command can change the horizontal (and vertical) motion unit. However, the value
	cannot be less than the minimum vertical movement amount, and it must be in even units of
	the minimum vertical movement amount.
	• In standard mode, the vertical motion unit (y) is used.
	• In page mode, this command functions as follows, depending on the starting position of the
	printable area:

①When the starting position is set to the upper left or lower right of the printable area using ESC T, the vertical motion unit (y) is used.

	② When the starting position is set to the upper right or lower left of the print able area
	using ESC T, the horizontal motion unit (x) is used.
	• The maximum paper feed amount is 1016 mm {40"}. Even if a paper feed amount of more
	than 1016 mm {40"} is set, the printer feeds the paper only 1016 mm {40"}.
[Default]	Line spacing equivalent to approximately 4.23mm {1/6"}.
[Reference]	ESC 2, GS P

EPSON	TITLE	TM-T88IIIseries	SHEET	NO.
			REVISION
		Specification
				NEXT	SHEET
		(STANDARD)	B
				88	87