Epson T88III specifications Installation

Confidential

3) Vibration resistance:	When Packed:	Frequency:	5 to 55 Hz
		Acceleration:	Approximately 19.6 m/s2 {2 G}
		Sweep:	10 minutes (half cycle)
		Duration:	1 hour
		Directions:	x, y, and z
	No external or internal damage should be found after the vibration test,
	and the unit should operate normally.
4) Impact resistance:	When Packed:	Package:	EPSON standard package
		Height:	60 cm {23.6"}
		Directions:	1 corner, 3 edges, and 6 surfaces
	No external or internal damage should be found after the
	drop test, and the unit should operate normally.
	When unpacked: Height:		5 cm {1.97"}
		Directions:	Lift one edge and release it
			(for all 4 edges).
	When the printer is not printing, no external or internal damage should
	be found after the drop test.
5) Acoustic noise(Operating):	When using autocutter:
		Approximately 55 dB (Bystander position)
	When not using autocutter:
		Approximately 45 dB (Bystander position)

1.13Installation

The TM-T88IIIseries printer must be installed horizontally.

(Vibration during paper cutting and using a drawer should be considered. Take measures to prevent the printer from moving. Affixing tapes are provided as an option.)

An optional hanging bracket can attach the printer to a wall. (Following the procedures describes in the installation manual, install the wall mount and change the location of the paper roll near-end sensor, then install the paper roll stopper and other parts.)

TITLE

TM-T88IIIseries

SHEET	NO.
REVISION

EPSON Specification (STANDARD)

B	NEXT	SHEET
	10	9