
| x0 = [(xL + xH ✕ 256) ✕ (horizontal motion unit)] |
| y0 = [(yL + yH ✕ 256) ✕ (vertical motion unit)] |
| dx = [dxL + dxH ✕ 256) ✕ (horizontal motion unit)] |
| dy = [dyL + dyH ✕ 256) ✕ (vertical motion unit)] |
| The printing area is set as shown in the figure below. |
[Notes] | • If this command is input in standard mode, the printer executes |
| only internal flag operation. This command does not affect |
| printing in standard mode. |
| • If the horizlntal or vertical starting position is set outside the |
| printable area, the printer stops command processing and |
| processes the following data as normal data. |
| • If the printing area width or height is set to 0, the printer stops |
| command processing and processes the following data as normal |
| data. |
| • This command sets the position where data is buffered to the |
| position specified by ESC T within the printing area. |
| • If (horizontal starting position + printing area width) exceeds the |
| printable area, the printing area width is automatically set to |
| (horizontal printable area - horizontal starting position). |
| • If (vertical starting position + printing area height ) exceeds the |
| printable area, the printing area height is automatically set to |
| (vertical printable area - vertical starting position ). |
| • The horizontal and vertical motion unit are specified by GS P. |
| Changing the horizontal or vertical motion unit does not affect the |
| current printing area. |
| • The GS P command can change the horizontal (and vertical) |
| motion unit. However, the value cannot be less than the minimum |
| horizontal movement amount, and it must be in even units of |
| minimum horizontal movement amount. |
| • Use the horizontal motion unit (x) for setting the horizontal |
| starting position and printing area width, and use the vertical |
| motion unit (y) for setting the vertical starting position and |
| printing area height. |