Everpure 327, 325 manual Setupcld.B, SETUPCLD.1A, Pct.Cld+.A, CRB.A12.00, Cld.A, Set Up A Drink

size of the selection.

Cold Drink Center (327/328) Operator’s Guide

SET UP A DRINK

Be sure that the cup sizes you set in "Set Up Cup Sizes" on page 35, agree with the cup sizes actually in your machine. All procedures for setting up the drinks are similar, so this example will demonstrate how to set up the A selection, regular size drink.

1. Press , then press until the display shows *. The

2. Press A. (If you were setting up the A selection for the large size drink, you

star (*) represents the selection (A, B, etc.). The dash (-) SETUPrepresents--the

	would press 1 first, then A.) The display shows something similar to:
	CLD.A		12.00		. This means that the currently set still water throw time for the
	A selection is 12.00 seconds. Enter a new time if desired.
3.	Press				. The display shows		. This means that the
						CRB.A12.00		*
	currently set carbonated water throw time for the A selection is 12.00
	seconds. Enter a new time if desired. A value of .00 will lock out carbonation
	for the selection.
4.	Pressing					after each display will cause the following screens to
	appear:
			View and change the settings for syrup
		AtView and change the settings for percentage of carbonation (0-100).
	PCT.CLD+.A						SETUPCLD.1A			SETUPCLD.B
			A value of 100 will lock out non-carbonation for the selection.
			View and change the settings for ice throw time
OPTIONS:ICE.			View and change the settings for extra ice throw time
	a.		any of the preceding displays, you can press						to test throw that
		item.
	b.		any of the preceding displays, you can press						or # (on the selection
		switch panel) to step through a list of that item's throw times for other
		selections where that item is active. For example, pressing # at the
				display will show the throw time for either					or		(depend-
		ing on how the drink sizes are set up). This is a handy way to move from
		one selection to another without going to the							screen first.
						NOTE
		If you try to set up a selection that is not configured, the
SRP.						screen will remain in the display.
August, 2003						Page 36					3280020