Auto Memory
The DVS 304 stores 16 auto memories with input and picture control data for each input. The default settings enables these memories to automatically recall input and picture controls for signals that have been previously applied. By disabling auto memories, the DVS 304 will treat every newly applied input as a new source. Default is on.
AUTO MEMORY AND AUTO IMAGE FEATURES
Auto Memory |
| Information |
|
|
|
On | On | “New” signals/rates that have not been previously detected by the |
|
| DVS 304 are initially |
|
| is automatically applied and values stored. The next time that signal is |
|
| detected, the values stored in the auto memory location are applied. |
|
|
|
On | Off | “New” signals/rates that have not been previously detected by the |
(Default) | (Default) | DVS 304 are |
|
| ture settings are made to the input, an auto memory location is |
|
| created and recalled each successive time the input is detected. |
|
|
|
Off | On | Each change in input sync triggers an automatic auto image. When auto |
|
| memory is disabled, each change in sync is treated as a new signal and |
|
| an automatic auto image is triggered. Any manual changes made to the |
|
| image and picture controls are lost each time a new rate is detected. |
Off | Off | Each change in input sync causes default values to be applied to the rate. |
|
| Any manual changes made to the image and picture controls are lost |
|
| when a new rate is applied. |
|
|
|
| Auto Memory | 16 per input | (64 total) |
| |
|
|
|
|
| |
Input Configuration | Aspect Ratio | Film Mode | H/V Start |
| |
|
|
|
| ||
Phase | Total Pixels | H/V Active | H/V Pan | ||
| |||||
|
|
|
|
| |
Picture controls | Zoom | Color/Tint | Bright/Cont | Detail | |
|
|
|
| ||
H/V Size | H/V Position |
|
| ||
|
|
| |||
|
|
|
|
|
Figure 21. Settings Saved When Auto Memory Is On.
Aspect Mode
The aspect mode setting is global, and allows the user to select between each input signal filling the entire output raster (Fill), or for each input rate to be displayed with its native aspect ratio (Follow - default setting).
When in the Fill mode, if an aspect ratio adjustment for a single input rate is desired, the desired setting (4x3 or 16x9) can be made in the input config menu by adjusting the aspect ratio setting. If auto memories is enabled, then this setting is saved and recalled the next time the signal is detected.
It is strongly recommended that the aspect ratio mode setting be used on initial setup of the DVS, or input rates that have not already been saved as auto memories may not be displayed as expected. This can be overcome by clearing the auto memories on the input in question, and is done by holding in the front panel Menu button and the applicable input button simultaneously for four seconds. Alternatively it can be cleared on a rate by rate basis by applying a one time auto image.
DVS 304 Series • Operation | 21 |
