DVS 304 Series • SIS Communication and Control

Command	ASCII (Telnet)	URL Encoded (Web)	Response	Additional description
	(host to processor)	(host to processor)	(processor to host)

Set IP address24	E X1$CI }	WX1$CI	Ipi • X1$ ]	X1$ = IP address (xxx.xxx.xxx.xxx).
				Leading zeros in each of the four fields are
				optional in setting values.
Read IP address24	ECI }	WCI	X1$]	Leading zeros in each of the four fields are
				suppressed in returned values.
Read hardware	ECH }	WCH	X1*]	X1* = hardware media access control (MAC)
address (MAC)				address (xx-xx-xx-xx-xx-xx).
Set subnet mask24	E X1(CS}	WX1(CS	Ips•X1( ]	X1( is the subnet mask (xxx.xxx.xxx.xxx).
				Syntax is the same as for the IP addresses.
				Leading zeros are optional in setting values.
Read subnet mask	ECS} E	WCS	X1( ]	Leading zeros are suppressed.
Set gateway IP address24	E X1$CG}	W X1$CG	Ipg•X1$ ]	X1$ is the IP address. Leading zeros are
				optional.
Read gateway IP address	ECG}	WCG	X1$ ]
Set broadcast mode	E X6$,X1$EB}	W X6$%2C X1$EB	BmdX6$, X1$ ]
Set administrator password 24	E X3#CA}	WX3#CA	Ipa•X3# ]	Set the administrator access password.
				(X3# is 4-12 alphanumeric characters)
				The password is case sensitive. Special
				characters (spaces or symbols) are
				not allowed.
Clear administrator	E•CA}	W%20CA	Ipa• ]	Clear/remove all passwords (administrator
password 24				and user)

NOTE: A user password cannot be assigned if an administrator password does not exist. Entering a password when the DVS 304 has not been configured yields an E14 response from the processor. If the administrator password is cleared (removed), the user password is also removed.

Read administrator password

ECA}

WCA

X3# ]

NOTE: X% = On/Off 0 = off/disable, 1 = on/enable
X1$	=	IP address (xxx.xxx.xxx.xxx); leading zeros in each of 4 fields are optional in setting values, and are suppressed in returned values.
X1*	=	Hardware (MAC) address (xx-xx-xx-xx-xxxx)
X1( = Subnet mask (xxx.xxx.xxx.xxx). Leading zeros are optional in setting values in each of four fields, and are suppressed in returned values.
X3# = Password (12 characters = maximum length; no special characters are allowed).
X6$ = Broadcast repetition rate in seconds (0 – 255 max; default = 0 = clear). The response is returned with leading zeros. 1 – 11 = entry without password goes to the level
		specified (if an admin password exists). The response as returned as 2-digits with a leading zero.

Extron electronic manual DVS 304 Series • SIS Communication and Control, E X1$CI

Models: DVS 304

E X1$CI }