|
|
Setting up FortiBridge units | Installing FortiBridge unit firmware |
Installing firmware from a system reboot
This procedure installs a specified firmware image and resets the FortiBridge unit to default settings. You can use this procedure to upgrade to a new firmware version, revert to an older firmware version, or to
To use this procedure you:
•access the CLI by connecting to the FortiBridge console port,
•install a TFTP server that you can connect to from the FortiBridge EXT 2 interface. The TFTP server should be on the same network as the EXT 2 interface. The FortiBridge unit cannot access the TFTP server if its behind a router.
During this procedure you will be asked to enter a local IP address for the FortiBridge unit. This is a temporary address used for downloading the firmware image.
This procedure reverts your FortiBridge unit to its factory default configuration. Before running this procedure you can backup the FortiBridge unit configuration using the command execute backup config.
To install firmware from a system reboot
1Connect to the CLI using the FortiBridge console port.
2Make sure the TFTP server is running.
3Copy the new firmware image file to the root directory of the TFTP server.
4Make sure the EXT 2 interface of the FortiBridge unit can connect to the TFTP server.
5Enter the following command to restart the FortiBridge unit: execute reboot
As the FortiBridge unit starts, a series of system startup messages are displayed. When the following messages appears:
Hit any key to stop autoboot:
6Immediately press any key to interrupt the system startup.
Note: You only have 3 seconds to press any key. If you do not press any key soon enough, the FortiBridge unit reboots and you must log in and repeat the execute reboot command.
When you successfully interrupt the startup process, the => prompt appears:
7Type upgrade and press Enter to get the new firmware image from the TFTP server.
The following message appears:
Enter TFTP server address [192.168.1.168]:
8Type the address of the TFTP server and press Enter. The following message appears:
Enter local address [192.168.1.188]:
9Type an IP address that the FortiBridge unit can use to connect to the TFTP server press Enter.
FortiBridge Version 3.0 Administration Guide | 33 |
