Fostex DV824 Entering the quick setup mode, Select the desired item and press the ENTER/YES key

DVD Multitrack Recorder DV824

Entering the quick setup mode

You can enter the quick setup mode by following the procedure below.

1)While "-No files!-" is shown on the Home screen, press the [QUICK SET] key.

By default, " INPUT " in the status information area flashes.

flashing

In this condition, rotating the [MENU] dial (or pressing the [SKIP/CURSOR ] key) moves the flashing position in the following order.

INPUT FRAME CLK FS/BIT

TRACK UP/DW TC GEN

2)Select the desired item and press the [ENTER/YES] key.

The current option of the selected item starts flashing and you can now select the option using the [MENU] dial.

3)Use the [MENU] dial to select the desired option and press the [ENTER/YES] key.

The selected option is set.

4)To exit the quick setup mode, press the [EXET/NO] key (or the [STOP/HOME]) key).

See the following for details about each item.

Input signal selection (" INPUT " of the status information area)

By selecting " INPUT " and pressing the [ENTER/YES] key, you can select the input signal between "Analog" (default) and " Digital". You can also make input signal selection via the "Select Input" item in the "SYS SETUP" menu of the MENU mode (see page 119 for details), as well as via the quick setup mode.

Analog You can record analog audio signals fed to the [ANALOG INPUT] connectors.

You can record digital audio signals (AES/EBU or S/P DIF) fed to the [DIGITAL I/0] Digital connector. The unit automatically detects the digital signal format (AES/EBU or S/

P DIF).

<Note>: If you select "Digital" but the unit does not receive correct digital signals from the [DIGITAL I/0] connector on the rear panel or does not lock to the digital input signals, "Digital" flashes quickly for warning. When the unit receive correct digital signals and lock to them, "Digital" is steadily lit.

<Note>: When "Digital" is selected, all channels can record digital signals by default. However, if you want to record analog and digital signals simulta- neously, set the "Setup digital in" menu item in the "SYS SETUP" menu of the MENU mode appropriately (see page 119 for details). You can select signal source between analog and digital in two channel pairs.

45