Fostex DV824 owner manual Time code output source selection Sel.TC Out, 131

DVD Multitrack Recorder DV824

Time code output source selection [Sel.TC Out]

Using the "Sel. TC Out" menu item, you can set the time code source (Repro or Gen) fed from the [TIME CODE OUT] connector.

<Note>: The "Sel. TC Out" menu item setting is effective only when the optional TC/ SYNC card is installed. When it is not installed, "Void! No TC Card" is shown and you cannot make setting.

Select the "Sel. TC Out" menu item and press the [ENTER/YES] key.

The current setting starts flashing and you can now select the desired option.

Use the [MENU] dial to select the desired option, and press the [ENTER/YES] key to confirm your setting. Press the [STOP/HOME] key to exit the MENU mode.

Options	Details
Repro	Outputs playback time code. This is the default.
Gen	Outputs the internal generator time code.

<Note>: Even if "Sel. TC Out" is set to "Gen", the generator time code is not output when the generator mode is set to the "EXT RUN" mode.

Default LTC start time setting [Default LTC start]

Using the "Default LTC start" menu item, you can set the desired default LTC start time value (the initial setting is "1h 00m 00s"). This value is used when the generator mode is set to "Ext Run" but no external time code is fed to the unit.

<Note>: The unit does not recognize paused time code as "correct" time code. It recognizes time code when receiving more than two continuous frames.

1)Select the "Default LTC start" menu item and press the [ENTER/YES key.

The current LTC start time is shown (initially, "1h 00m 00s" is shown).

2)Press the [ENTER/YES] key again.

The second value flashes and you can now edit the default LTC start time.

131