Fostex DV824 Recording tracks 7GB 7GB 3x speed, 22.05kHz/16bit, 44.1kHz/16bit, 48kHz/16bit, +0.1%

DVD Multitrack Recorder DV824

<Note>: The LTC start time is set to "01h00m00s00f" by default. You can edit it via the "Default LTC start" menu item in the "TC SETUP" menu of the MENU mode (see page 131 for details). For details about the TC generator mode when the optional TC/SYNC card is installed, see page 77. You can also select a TC recording mode via the "Gen mode" menu item in the "TC SETUP" menu of the MENU mode (see page 132 for details).

Recording track selection (“ TRACK ” of the status information area)

By selecting " TRACK " and pressing the [ENTER/YES] key, you can select the number of recording tracks from among "1", "2", "4", "6" and "8" (the default is "8".)

You can also select the number of recording tracks via the "Record tracks" menu item in the "SYS SETUP" menu of the MENU mode (see page 117 for details).

Depending on a DVD-RAM disk, there are some restrictions as shown in the table below.

FS/BIT	Recording tracks	4.7GB	4.7GB (3x speed)	Recordable time (minutes)
				22.05kHz	44.1kHz	48kHz
	Mono	Yes	Yes	1,676	838	770
	Stereo	Yes	Yes	838	419	385
22.05kHz/16bit
	Multi (4 track)	Yes	Yes	418	209	192
44.1kHz/16bit
	Multi (5 track)	Yes	Yes	334	167	154
48kHz/16bit
	Multi (6 track)	Yes	Yes	279	140	128
	Multi (8 track)	Yes	Yes	209	105	96
				44.1kHz		48kHz
	Mono	Yes	Yes	558		513
	Stereo	Yes	Yes	279		256
44.1kHz/24bit	Multi (4 track)	Yes	Yes	139		128
	Multi (5 track)	Yes	Yes	111		102
48kHz/24bit
	Multi (6 track)	Yes	Yes	93		85

	Multi (8 track)	No	Yes	69	64
				88.2kHz	96kHz
	Mono	Yes	Yes	279	256
	Stereo	Yes	Yes	139	128
88.2kHz/24bit	Multi (4 track)	No	Yes	69	64
	Multi (5 track)	No	No
96kHz/24bit	Multi (6 track)	No	No
	Multi (8 track)	No	No

Clock pull up/pull down setting (“ UP/DW ” of the status information area)

When the optional TC/SYNC card is installed, this item allow making the pull up/pull down setting of the sampling clock/internal TC frame rate if the clock reference is set to “INT”.

By selecting “ UP/DW ” and pressing the [ENTER/YES] key, you can select from among “0.0%” (default), “+0.1%” and “-0.1%”.

You can also make the pull up/pull down setting via the “Pull Up/Down” menu item in the “SYS SETUP” menu of the MENU mode (see page 118 for details).

+0.1%	The current FS and internal TC frame rate are pulled up +0.1%.
0.0%	Normal setting (default).
-0.1%	The current FS and internal TC frame rate are pulled down -0.1%.

48