2

3

Remove the blue thumbscrew from its existing position on the left tab.Slide the tray sections apart as far as the tab slots allow.

4 Reinstall the blue thumbscrew in the new position on the right tab, securing the tray extension in the back position.

Replacing the sub-bezel

The installed sub-bezel on the LCP control panel module must be replaced with the new sub-bezel included with your server.

To replace the sub-bezel:

1 Use a flat-blade screwdriver to lift the metal retention tabs on both sides of the LCP control panel module, then pull the sub-bezel off of the front of the module.

Warning Use a flat-blade screwdriver to lift the metal retention tabs. Failure to

do so could result in injury to fingers or fingernails.

Metal retention tabs

2 Align the new sub-bezel with the LCP control panel, then press it until it clicks into place.

www.gateway.com

101