3 Connect the USB cable to the control panel module, then slide the module into the chassis until it clicks into place.

4

5

Connect the front panel cable to the hot-swap backplane.Replace the bezel by snapping it into place on the front of the server.

Important If you are replacing the standard control panel module with the optional LCP control panel module and decide to use the optional bezel, you are required to reconfigure the LCP module for use with the bezel. For information on reconfiguring the LCP control panel module tray, see “Reconfiguring the LCP control panel module tray” on page 100.

6 Follow the instructions in “Closing the server case” on page 44.

Reconfiguring the LCP control panel module tray

The LCP control panel module tray must be made longer in order for the control panel to be flush with the front of the optional bezel.

To reconfigure the LCP control panel module tray:

1 With the LCP control panel module tray removed from the server, locate the blue thumbscrew that secures the tray extension in position on the module tray.

Existing position of the blue thumbscrew (on the left tab)

Tray extension

LCP control panel

module tray

New position of the blue thumbscrew (on the right tab)

Tab slot

100

www.gateway.com